Concrete driveway crack sealer
Concrete driveway crack sealer is needed when your driveway floor cracks. Usually the driveway concrete floor cracks because high usage and so many other reasons. In this article you will learn how to do concrete driveway repair with the easiest way.
Usually driveways are made from asphalt or concrete. The quality of the materials is very important for the concrete lifespan. Concrete driveway also becomes more popular because it has various decorative options.
Commonly, materials that are used to create concrete driveway are cement, gravel, sand and water. Gravel and sand is bond together by the cement. This process creates chemical reaction and happens when water is added to the cement. As results, it will form small crystals. All of this crystals form a mesh which holds gravel particle and irregular sand together. The stronger the bond and the more the crystals formed, the longer your concrete driveway will last.
The cause of cracks on concrete driveway floor is movement of the soil, very cold temperatures or roots of tree. You could spend a lot of money by installing new concrete driveway floor or you can repair those cracks. Here is a technique to apply concrete driveway crack sealer.
Applying concrete driveway crack sealer
Required tools and material for apply concrete driveway crack sealers are Cleaning solution, Trowel, Hose, Mixing paddle, extended handle, pressure washer, bucket with 5 gallon capacity, cordless drill, water, float, broom, concrete resurfaces mix and rubber squeegee with a long handle.
Steps on applying concrete driveway crack sealer
Stage 1
Clean the whole concrete driveway floor using a power washer. In this process mix the water with specially manufactured masonry cleaning solution. Remove all accumulated dirt from the cracks. The sealant will not hold the crack and stick well if you not remove the dirt.
Stage 2
Check out the cracks and estimate the amount of the concrete mix that you’ll use. Fill the 5 gallon bucket with water and add resurface mix cement. Mix the materials using a cordless drill with an attached mixing paddle. Mix it until it feels like a pudding and gets thick.
Stage 3
Use the concrete mixture to fill all cracks and push it tight into the cracks using a trowel. After all the cracks are patched, smooth the surface using a float. The next step is let the concrete mixture dry for about 16 to 17 hours or overnight.
Stage 4
On the Next day, make the concrete resurface mixture again. Make sure you add less of resurface mix and more water this time. In order to make the resurface mix is thinner than before. Before you pour down the mixture on the entire surface, you need to spray the driveway with water using a hose. In order to spread the mixture evenly, you can use rubber squeegee. In this step make sure you covered the driveway using the mixture.
Stage 5
By the way to make you driveways less slippery when it’s wet, you can make a texture look by sweeping it with a broom. The last step leaves the driveway dry for 7 to 9 hours. Drive you car only after 24 hours. I hope this Concrete driveway crack sealer article will be useful.